Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH 사용자 설명서

configure vlan <vlan_name> router-discovery {ipv6} set prefix <prefix> 

[autonomous-flag <auto_on_off> | onlink-flag <onlink_on_off> | 

preferred-lifetime <preflife> |valid-lifetime <validlife>]

To reset all router discovery settings to their default values, enter the following command:

unconfigure vlan <vlan_name> router-discovery {ipv6}

To reset an individual router discovery setting to its default value, enter one of the following 
commands:

unconfigure vlan <vlan_name> router-discovery {ipv6} default-lifetime

unconfigure vlan <vlan_name> router-discovery {ipv6} hop-limit

unconfigure vlan <vlan_name> router-discovery {ipv6} link-mtu

unconfigure vlan <vlan_name> router-discovery {ipv6} managed-config-flag

unconfigure vlan <vlan_name> router-discovery {ipv6} max-interval

unconfigure vlan <vlan_name> router-discovery {ipv6} min-interval

unconfigure vlan <vlan_name> router-discovery {ipv6} other-config-flag

unconfigure vlan <vlan_name> router-discovery {ipv6} reachable-time

unconfigure vlan <vlan_name> router-discovery {ipv6} retransmit-time

To display router discovery settings, use the following command:

show router-discovery {ipv6} {vlan <vlan_name>}

Managing Tunnels

IPv6-in-IPv4 and IPv6-to-IPv4 tunnels are introduced in 

on page 640. The following 

sections describe how to manage tunnels:

To create an IPv6-in-IPv4 tunnel, use the following command:

create tunnel <tunnel_name> ipv6-in-ipv4 destination <destination-address> 

source <source-address>

The 

source-address

 refers to an existing address in the switch, and the 

destination-address

 

is a remote destination accessible from the switch. A maximum of 255 IPv6-in-IPv4 tunnels 
can be configured.