Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH 사용자 설명서
Chapter 24. OSPF
|
681
NETGEAR 8800 User Manual
Note:
All routers in the VLAN must have the same OSPF link type. If there
is a mismatch, OSPF attempts to operate, but it may not be reliable.
Route Redistribution
More than one routing protocol can be enabled simultaneously on the switch. Route
redistribution allows the switch to exchange routes, including static routes, between the
routing protocols.
redistribution allows the switch to exchange routes, including static routes, between the
routing protocols.
is an example of route redistribution between an OSPF AS and
a RIP AS.
Figure 74. Route Redistribution
Configuring Route Redistribution
Exporting routes from one protocol to another and from that protocol to the first one are
discrete configuration functions. For example, to run OSPF and RIP simultaneously, you
must first configure both protocols and then verify the independent operation of each. Then
you can configure the routes to export from OSPF to RIP and the routes to export from RIP to
OSPF. Likewise, for any other combinations of protocols, you must separately configure each
to export routes to the other.
discrete configuration functions. For example, to run OSPF and RIP simultaneously, you
must first configure both protocols and then verify the independent operation of each. Then
you can configure the routes to export from OSPF to RIP and the routes to export from RIP to
OSPF. Likewise, for any other combinations of protocols, you must separately configure each
to export routes to the other.
Redistributing Routes into OSPF
To enable or disable the exporting of BGP, RIP, static, and direct (interface) routes to OSPF,
use the following commands:
use the following commands:
enable ospf export [bgp | direct | e-bgp | i-bgp | rip | static] [cost <cost>
type [ase-type-1 | ase-type-2] {tag <number>} | <policy-map>]
EX_046
OSPF AS
Backbone Area
0.0.0.0
Area
121.2.3.4
ABR
ASBR
ASBR
RIP AS