Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH 사용자 설명서
Chapter 25. OSPFv3
|
693
NETGEAR 8800 User Manual
Route Redistribution
More than one routing protocol can be enabled simultaneously on the switch. Route
redistribution allows the switch to exchange routes, including static routes, between the
routing protocols.
redistribution allows the switch to exchange routes, including static routes, between the
routing protocols.
is an example of route redistribution between an OSPFv3 AS
and a RIPng AS.
Figure 78. Route Redistribution
Configuring Route Redistribution
Exporting routes from one protocol to another and from that protocol to the first one are
discrete configuration functions. For example, to run OSPFv3 and RIPng simultaneously, you
must first configure both protocols and then verify the independent operation of each. Then
you can configure the routes to export from OSPFv3 to RIPng and the routes to export from
RIPng to OSPFv3. Likewise, for any other combinations of protocols, you must separately
configure each to export routes to the other.
discrete configuration functions. For example, to run OSPFv3 and RIPng simultaneously, you
must first configure both protocols and then verify the independent operation of each. Then
you can configure the routes to export from OSPFv3 to RIPng and the routes to export from
RIPng to OSPFv3. Likewise, for any other combinations of protocols, you must separately
configure each to export routes to the other.
Redistributing Routes into OSPFv3
To enable or disable the exporting of RIPng, static, and direct (interface) routes to OSPFv3,
use the following commands:
use the following commands:
enable ospfv3 {domain <domainName>} export [direct | ripng | static]
[cost <cost> type [ase-type-1 | ase-type-2] | <policy-map>]
disable ospfv3 {domain <domainName>} export [direct | ripng | static]
EX_046
OSPF AS
Backbone Area
0.0.0.0
Area
121.2.3.4
ABR
ASBR
ASBR
RIP AS