Netgear XCM8806 - 8800 SERIES 6-SLOT CHASSIS SWITCH 사용자 설명서
786
Chapter 30. vMAN (PBN)
8800 Chassis Switch
1.
If you are configuring a NETGEAR 8800, enable jumbo frames on the switch.
Note:
Because the NETGEAR 8800 switch enables jumbo frames
switch-wide, you must enable jumbo frames before configuring vMANs on
NETGEAR systems.
NETGEAR systems.
2.
Create a vMAN by entering the following command:
create vman <vman-name> {vr <vr_name>}
3.
Assign a tag value to the vMAN by entering the following command:
configure vman <vman-name> tag <tag>
4.
Add ports to the vMAN by entering the following command:
configure vman <vman-name> add ports [ all | <port_list> ] {untagged | tagged
| svid <svid>}
Specify
tagged
for network (switch-to-switch) vMAN ports, and specify
untagged
for
access (ingress and egress) vMAN ports.
Note:
You must configure the vMAN egress port as untagged so that the
S-tag is stripped from the frame.
5.
6.
To configure a VLAN to use a vMAN, configure the VLAN on the switch port at the other end
of the line leading to the vMAN access port.
of the line leading to the vMAN access port.
Configuring vMAN Options
Note:
You can use ACLs to configure some vMAN options. For more
information, see
Configuring the Ethertype for vMAN Ports
The ethertype is a component of VLAN and vMAN frames and is introduced in
To configure the ethertype for vMAN (PBN) ports, do the following:
1.
Configure the primary and secondary (if needed) vMAN ethertype values for the switch
using the following command:
using the following command: