Netgear FVS336Gv2 – ProSafe Dual WAN Gigabit Firewall with SSL & IPSec VPN 참조 매뉴얼



On your computer, launch an Internet browser.

In the address field of your browser, enter the IP address that was assigned to the VPN 
firewall during the installation process.

The VPN firewall factory default IP address is 192.168.1.1.

The NETGEAR Configuration Manager Login screen displays.

In the Username field, type your user name and in the Password / Passcode field, type 
your password.

For the default administrative account, the default user name is admin and the default 
password is password.

If you changed the default domain or were assigned a domain, from the Domain menu, 
select the domain.

If you did not change the domain or were not assigned a domain, leave the menu 
selection at geardomain.

Click the Login button.

The Router Status screen displays.

Select Monitoring > Diagnostics.

The Diagnostics screen displays the IPv4 settings.

In the Schedule Reboot section, select the Schedule Reboot check box.

The Reboot Time fields become accessible.

In the Reboot Time fields, enter the hour in 24-hour format (1–23) and the minute (1–59) to 
specify the time that the VPN firewall must reboot.

Click the Apply button.

The VPN firewall is scheduled to reboot.

This section provides information about troubleshooting basic functioning of the VPN firewall.



When power is first applied, verify that the Power LED lights.

After approximately two minutes, verify the following:

a. The Test LED no longer lights (it turns off after approximately two minutes).

b.  The left LAN port LEDs light for any local ports that are connected.

c.  The left WAN port LEDs light for any WAN ports that are connected.