Netgear FVS318N – Prosafe Wireless N VPN Firewall 참조 매뉴얼
IPv4 and IPv6 Internet and Broadband Settings
26
ProSAFE Wireless-N 8-Port Gigabit VPN Firewall FVS318N
Internet and WAN Configuration Tasks
The tasks that are required to complete the Internet connection of your wireless VPN firewall
depend on whether you use an IPv4 connection or an IPv6 connection to your Internet
service provider (ISP).
depend on whether you use an IPv4 connection or an IPv6 connection to your Internet
service provider (ISP).
Note:
The wireless VPN firewall supports simultaneous IPv4 and IPv6
connections.
connections.
Roadmap to Setting Up an IPv4 Internet Connection to Your
ISP
ISP
Setting up an IPv4 Internet connection to your ISP includes five tasks, three of which are
optional.
optional.
Complete these tasks:
1.
Configure the IPv4 WAN mode. Select either NAT or classical routing.
This task is described in
28.
2.
Configure the IPv4 Internet connection to your ISP. Connect to your ISP.
You have two configuration options. These tasks are described in the following sections:
•
•
3.
(Optional) Configure Dynamic DNS on the WAN port. If necessary, configure your fully
qualified domain names.
qualified domain names.
This task is described in
36.
4.
(Optional) Configure the WAN options. If necessary, change the factory default MTU size,
port speed, and MAC address of the wireless VPN firewall. These are advanced features,
and you usually do not need to change the settings.
port speed, and MAC address of the wireless VPN firewall. These are advanced features,
and you usually do not need to change the settings.
51.
5.
(Optional) Configure the WAN traffic meters.
This task is described in