Netgear FVS318N – Prosafe Wireless N VPN Firewall 참조 매뉴얼
Monitor
System
Access
and
Performance
357
ProSAFE Wireless-N 8-Port Gigabit VPN Firewall FVS318N
The following sections describe steps 2 through 4, using the topology that is described in the
following table:
following table:
Configure Gateway 1 at Site 1
To create a gateway-to-gateway VPN tunnel to Gateway 2, using the IPSec VPN wizard:
1.
Select VPN > IPSec VPN > VPN Wizard. The VPN Wizard screen displays.
2.
Configure a gateway-to-gateway VPN tunnel using the following information:
•
Connection name. Any name of your choice
•
Pre-shared key. Any key of your choice
•
Remote WAN IP address. 10.0.0.2
•
Local WAN IP address. 10.0.0.1
•
Remote LAN IP Address. 192.168.20.0
•
Remote LAN subnet mask. 255.255.255.0
3.
Click Apply to save the settings.
To change the remote IP address in the VPN policy:
1.
Select VPN > IPSec VPN > VPN Policies. The VPN Policy screen displays.
2.
Next to the policy name for the Gateway 1–to–Gateway 2 autopolicy, click Edit. The Edit
VPN Policy screen displays.
VPN Policy screen displays.
3.
In the General section of the screen, clear the Enable NetBIOS check box.
4.
In the Traffic Selector section of the screen, make the following changes:
•
From the Remote IP drop-down list, select Single.
•
In the Start IP fields, type 10.0.0.2, which is the WAN IP address of Gateway 2.
5.
Click Apply to save the settings.
Configure Gateway 2 at Site 2
To create a gateway-to-gateway VPN tunnel to Gateway 1, using the IPSec VPN wizard:
1.
Select VPN > IPSec VPN > VPN Wizard. The VPN Wizard screen displays.
2.
Configure a gateway-to-gateway VPN tunnel using the following information:
•
Connection name. Any name of your choice
•
Pre-shared key. The same key as you configured on Gateway 1
Type of Address
Gateway 1 at Site 1 Gateway 2 at Site 2
WAN IP address
10.0.0.1
10.0.0.2
LAN IP address
192.168.10.0
192.168.20.0
LAN subnet mask
255.255.255.0
255.255.255.0
LAN IP address syslog server
192.168.10.2
Not applicable