Netgear FVS318N – Prosafe Wireless N VPN Firewall 참조 매뉴얼
Monitor
System
Access
and
Performance
358
ProSAFE Wireless-N 8-Port Gigabit VPN Firewall FVS318N
•
Remote WAN IP address. 10.0.0.1
•
Local WAN IP address. 10.0.0.2
•
Remote LAN IP Address. 192.168.10.0
•
Remote LAN subnet mask. 255.255.255.0
3.
Click Apply to save the settings.
To change the local IP address in the VPN policy:
1.
Select VPN > IPSec VPN > VPN Policies. The VPN Policy screen displays.
2.
Next to the policy name for the Gateway 2–to–Gateway 1 autopolicy, click Edit. The Edit
VPN Policy screen displays.
VPN Policy screen displays.
3.
In the General section of the screen, clear the Enable NetBIOS check box.
4.
In the Traffic Selector section of the screen, make the following changes:
•
From the Local IP drop-down list, select Single.
•
In the Start IP fields, type 10.0.0.2, which is the WAN IP address of Gateway 2.
5.
Click Apply to save the settings.
To specify the syslog server that is connected to Gateway 1:
1.
Select Monitoring > Firewall Logs & E-mail. The Firewall Logs & E-mail screen
displays.
displays.
2.
Enable the syslog server and specify its IP address at Site 1. Enter 192.168.10.2 as the IP
address.
address.
3.
Click Apply to save the settings.
Note:
The VPN tunnel should be established automatically, and the
syslogs should be sent to the syslog server at Site 1. You can use
the IPSec VPN Connection Status screen to verify the connection.
syslogs should be sent to the syslog server at Site 1. You can use
the IPSec VPN Connection Status screen to verify the connection.