Netgear FVS318v3 – Cable/DSL ProSafe VPN Firewall with 8-Port Switch 참조 매뉴얼
ProSafe VPN Firewall FVS318v3 Reference Manual
Basic Virtual Private Networking
4-29
v5.0, January 2012
b. On the Windows taskbar, click the Start button, and then click Run.
c. Type ping -t 192.168.3.1
and then click OK.
Figure 4-34
This will cause a continuous ping to be sent to the first FVS318v3. Within two minutes,
the ping response should change from “timed out” to “reply.”
the ping response should change from “timed out” to “reply.”
Note: Use Ctrl-C to stop the pinging.
Figure 4-35
Once the connection is established, you can open the browser of the PC and enter the LAN IP
address of the remote FVS318v3. After a short wait, you should see the login screen of the
VPN Firewall (unless another PC already has the FVS318v3 management interface open).
address of the remote FVS318v3. After a short wait, you should see the login screen of the
VPN Firewall (unless another PC already has the FVS318v3 management interface open).
•
Gateway-to-Gateway Configuration. Test the VPN tunnel by pinging the remote network
from a PC attached to the FVS318v3.
from a PC attached to the FVS318v3.
a. Open a command prompt (Start -> Run -> cmd).
b. Type ping 192.168.3.1.