Netgear FVS318v3 – Cable/DSL ProSafe VPN Firewall with 8-Port Switch 참조 매뉴얼
ProSafe VPN Firewall FVS318v3 Reference Manual
4-28
Basic Virtual Private Networking
v5.0, January 2012
Figure 4-32
3. Click VPN Status (
) to get the Current VPN Tunnels (SAs) screen (
).
Click Connect for the VPN tunnel you want to activate.
Figure 4-33
Pinging the Remote Endpoint
To activate the VPN tunnel by pinging the remote endpoint (192.168.3.1), do the following steps
depending on whether your configuration is client-to-gateway or gateway-to-gateway:
depending on whether your configuration is client-to-gateway or gateway-to-gateway:
•
Client-to-Gateway Configuration. To check the VPN Connection, you can initiate a request
from the remote PC to the FVS318v3’s network by using the “Connect” option in the
NETGEAR ProSafe menu bar. The NETGEAR ProSafe client will report the results of the
attempt to connect. Since the remote PC has a dynamically assigned WAN IP address, it must
initiate the request.
from the remote PC to the FVS318v3’s network by using the “Connect” option in the
NETGEAR ProSafe menu bar. The NETGEAR ProSafe client will report the results of the
attempt to connect. Since the remote PC has a dynamically assigned WAN IP address, it must
initiate the request.
To perform a ping test using our example, start from the remote PC:
a. Establish an Internet connection from the PC.