Netgear FVS318Gv2 – ProSAFE VPN Firewall Series 참조 매뉴얼

To reset the VPN firewall to the original factory default settings, you can use one of the 
following two methods:

Press the factory default Reset button on the rear panel of the VPN firewall and hold the 
button for about eight seconds until the Test LED turns on and begins to blink (about 30 
seconds). 

For information about how to locate the Reset button, see 

on page 16. To 

restore the factory default settings when you do not know the administration password or 
IP address, you must use the factory default Reset button method.

Use the Default button on the Settings Backup and Firmware Upgrade screen:

Log in to the unit:
a.  In the address field of any of the qualified web browsers, enter 

https://192.168.1.1.

The NETGEAR Configuration Manager Login screen displays. 

b.  In the Username field, enter admin and in the Password / Passcode field, 

enter password.

Use lowercase letters. If you changed the password, enter your personalized 
password. Leave the domain as it is (geardomain).

c.  Click the Login button.

The Router Status screen displays. After five minutes of inactivity, which is the 
default login time-out, you are automatically logged out.

Select Administration > Settings Backup & Upgrade.

Click the Default button.

The VPN firewall reboots. During the reboot process, the Settings Backup and Firmware 
Upgrade screen might remain visible, or a status message with a counter might show the 
number of seconds left until the reboot process is complete.