Netgear FVS318Gv2 – ProSAFE VPN Firewall Series 참조 매뉴얼
Troubleshooting
398
NETGEAR ProSAFE VPN Firewall FVS318G v2
The reboot process takes about 165 seconds. The reboot process is complete when the
Test LED on the front panel goes off.
Test LED on the front panel goes off.
WARNING:
When you press the hardware factory default Reset button or click
the software Default button, the VPN firewall settings are erased. All
firewall rules, VPN policies, LAN and WAN settings, and other
settings are lost. Back up your settings if you intend to use them.
the software Default button, the VPN firewall settings are erased. All
firewall rules, VPN policies, LAN and WAN settings, and other
settings are lost. Back up your settings if you intend to use them.
Note:
After you reboot with factory default settings, the VPN firewall’s
password is password, and the LAN IPv4 address is 192.168.1.1.
password is password, and the LAN IPv4 address is 192.168.1.1.
Address Problems with Date and Time
The System Date & Time screen displays the current date and time of day (see
on page 345). The VPN firewall uses the Network Time Protocol
(NTP) to obtain the current time from one of several network time servers on the Internet.
Each entry in the log is stamped with the date and time of day.
Each entry in the log is stamped with the date and time of day.
Problems with the date and time function can include the following:
•
Date shown is January 1, 2000.
Cause: The VPN firewall did not yet successfully reach a network time server. Check that
your Internet access settings are configured correctly. If you just completed configuring
the VPN firewall, wait at least five minutes, and check the date and time again.
your Internet access settings are configured correctly. If you just completed configuring
the VPN firewall, wait at least five minutes, and check the date and time again.
•
Time is off by one hour.
Cause: The VPN firewall does not automatically sense daylight saving time. Go to the
Time Zone screen (Administration > Time Zone), and select or clear the Automatically
Adjust for Daylight Savings Time check box.
Time Zone screen (Administration > Time Zone), and select or clear the Automatically
Adjust for Daylight Savings Time check box.
Access the Knowledge Base and Documentation
To access NETGEAR’s knowledge base for the VPN firewall:
Select Web Support > Knowledgebase.
To access NETGEAR’s documentation library for your VPN firewall model:
Select Web Support > Documentation.