Netgear WN203 - ProSAFE® WIRELESS-N SINGLE BAND ACCESS POINT 사용자 설명서
Introduction
11
ProSAFE Single Band 802.11n Wireless Access Point WN203
•
Auto or long preamble
•
Roaming among wireless access points on the same subnet
Autosensing Ethernet Connections with Auto Uplink
The wireless access point can connect to a standard Ethernet network. The LAN interface is
autosensing and capable of full-duplex or half-duplex operation.
autosensing and capable of full-duplex or half-duplex operation.
The wireless access point incorporates Auto Uplink technology. The Ethernet port
automatically senses whether the Ethernet cable plugged into the port should have a
“normal” connection such as to a computer or an “uplink” connection such as to a switch or
hub. That port then configures itself correctly. This feature also eliminates any concerns
about crossover cables, because Auto Uplink accommodates either type of cable to make
the right connection.
automatically senses whether the Ethernet cable plugged into the port should have a
“normal” connection such as to a computer or an “uplink” connection such as to a switch or
hub. That port then configures itself correctly. This feature also eliminates any concerns
about crossover cables, because Auto Uplink accommodates either type of cable to make
the right connection.
Hardware Description
This section describes the front and back hardware functions of the wireless access point.
•
•
•
Front Panel
The LEDs of the wireless access point are described in the following figure and table:
Figure 1. Front panel with LEDs
1
2
3
4