Netgear WN203 - ProSAFE® WIRELESS-N SINGLE BAND ACCESS POINT 사용자 설명서
Installation and Basic Configuration
17
ProSAFE Single Band 802.11n Wireless Access Point WN203
Connect the Wireless Access Point to a Computer
Tip:
Before you place the wireless access point in an elevated position that is
difficult to reach, first set up and test the wireless access point to verify
wireless network connectivity.
difficult to reach, first set up and test the wireless access point to verify
wireless network connectivity.
To set up the wireless access point:
1.
Unpack the box and verify the contents.
2.
Prepare a computer with an Ethernet adapter:
a. If this computer is already part of your network, record its TCP/IP configuration
settings.
b. Configure the computer with a static IP address of 192.168.0.210 and 255.255.255.0
as the subnet mask.
3.
Connect an Ethernet cable to the Ethernet port (
A
) of the computer.
4.
Securely insert the other end of the Ethernet cable into the wireless access point’s LAN
port (
port (
B
).
5.
Turn on your computer.
6.
Connect the power adapter to the wireless access point.
Tip:
The wireless access point supports Power over Ethernet (PoE). If you
have a switch that provides PoE, you do not need to use the power
adapter to power the wireless access point. Using PoE can be especially
convenient when the wireless access point is installed in a high location
far away from a power outlet.
have a switch that provides PoE, you do not need to use the power
adapter to power the wireless access point. Using PoE can be especially
convenient when the wireless access point is installed in a high location
far away from a power outlet.
7.
Verify the following:
Power LED. The Power LED is green. If the Power LED is off, check the
connections, and check if the power outlet is controlled by a wall switch that is
turned off.
connections, and check if the power outlet is controlled by a wall switch that is
turned off.
A
B