Netgear WN203 - ProSAFE® WIRELESS-N SINGLE BAND ACCESS POINT 사용자 설명서

The wireless access point connects to your LAN using twisted-pair Category 5 Ethernet cable 
with RJ-45 connectors.

For the initial configuration of your wireless access point, you need to connect a computer to 
the wireless access point.

To connect to the wireless access point on your network, each computer needs to have an 
802.11b/g/n wireless adapter installed.

The fourth octet of an IP address needs to be between 0 and 255 (both inclusive). This 
requirement applies to any IP address that you enter on a screen of the web management 
interface.

Install and configure your wireless access point in the order of the following sections:

1. Connect the Wireless Access Point to a Computer

2. Log In to the Wireless Access Point

3. Configure Basic General System Settings and Time Settings

4. Configure the IP Settings

5. Configure the Optional DHCP Server

6. Configure the Basic Wireless Settings

Before installing the wireless access point, make sure that your Ethernet network functions. 

After you have connected the wireless access point to the Ethernet network, computers with 

802.11b/g/n wireless adapters are able to communicate with the Ethernet network.

Before you start the installation and configuration process, verify that you have met all the 
system requirements. See