Netgear WAG302v2- ProSAFE Dual Band Wireless Access Point 참조 매뉴얼

4-10

Advanced Configuration

Multi-point bridge mode allows a wireless access point to bridge to multiple peer wireless access 
points simultaneously. In addition, you can enable client associations with this WAG302v2. Multi-
Point Bridge mode configuration includes the following steps:

•

Enter the MAC addresses of the other access points in the fields provided. 

•

Set the other bridge-mode access points to Point-to-Point Bridge mode, using the MAC 
address of this WAG302v2 as the Remote MAC Address. 

•

Use wireless security to protect this traffic. 

The figure below shows an example of a Multi-Point Bridge mode configuration.

The following steps describe how to set up the Multi-Point Bridge configuration shown in 

.

1. Configure the Operating Mode of the WAG302v2 Wireless Access Points.

•

Because it is in a central location, configure WAG302v2 (AP 1) on LAN Segment 1 in 
Point-to-Multi-Point Bridge mode and enter the MAC addresses of AP 2 and AP 3 in the 
Remote MAC Address 1 and Remote MAC Address 2 fields.

AP 1

AP 2

Router

Internet

Hub or Switch

192.168.0.1

PCs

PCs

AP 3

“Master AP”

PCs

Hub or Switch

Point-to-Multi-Point

Bridge mode

Point-to-Point

Bridge Mode

Point-to-Point
Bridge Mode