Netgear GSM7224v2 - 24-Port Layer 2 Managed Gigabit Switch 사용자 설명서
Chapter 4. Routing
|
267
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
Basic
From the Basic link, you can access the following pages:
OSPF Configuration
Use the OSPF Configuration page to enable OSPF on a router and to configure the related
OSPF settings.
OSPF settings.
To display the OSPF Configuration page, click Routing
OSPF
Basic
OSPF
Configuration.
1.
Use Router ID to specify a 32-bit integer in dotted decimal format that uniquely identifies
the router within the autonomous system (AS). To change the Router ID you must first
disable OSPF. After you set the new Router ID, you must re-enable OSPF to have the
change take effect. The default value is 0.0.0.0, although this is not a valid Router ID.
the router within the autonomous system (AS). To change the Router ID you must first
disable OSPF. After you set the new Router ID, you must re-enable OSPF to have the
change take effect. The default value is 0.0.0.0, although this is not a valid Router ID.
2.
Use Admin Mode to select enable or disable. If you select enable, OSPF will be activated
for the switch. The default value is disable. You must configure a Router ID before OSPF
can become operational; see step 1 or by issuing the CLI command:
(Config-router)#router-id
for the switch. The default value is disable. You must configure a Router ID before OSPF
can become operational; see step 1 or by issuing the CLI command:
(Config-router)#router-id
.