Netgear WAC720- ProSAFE® Business 2 x 2 Dual Band Wireless-AC Access Point 사용자 설명서

IP addresses assigned to the access points must follow the following requirements for IPv4 
and IPv6 addresses.

The fourth octet of an IP address must be between 0 and 255 (both inclusive). This 
requirement applies to any IP address that you enter on the access point’s web management 
interface.

IPv6 addresses are denoted by eight groups of hexadecimal quartets that are separated by 
colons. Any four-digit group of zeroes within an IPv6 address can be reduced to a single zero 
or altogether omitted.

The following errors invalidate an IPv6 address:

More than eight groups of hexadecimal quartets

More than four hexadecimal characters in a quartet

More than two colons in a row

Install and configure your access point in the order of the following sections:

1.  Connect the Access Point to a Computer

4.  Configure Basic General System Settings

Before installing the access point, make sure that your Ethernet network functions. After you 
connect the access point to the Ethernet network, computers that support 802.11b/g/a/n/ac 
are able to communicate with the Ethernet network.

For this to work correctly, verify that you meet all the system requirements, shown in