Netgear M4200-10MG-PoE+ (GSM4210P) - Multigigabit Managed Switch with 8*2.5G and 2x10G SFP+ Layer 3 소프트웨어 가이드

(NETGEAR Switch)#show ip helper statistics

DHCP client messages received.................. 8

DHCP client messages relayed................... 2

DHCP server messages received.................. 2

DHCP server messages relayed................... 2

UDP client messages received................... 8

UDP client messages relayed.................... 2

DHCP message hop count exceeded max............ 0

DHCP message with secs field below min......... 0

DHCP message with giaddr set to local address.. 0

Packets with expired TTL....................... 0

Packets that matched a discard entry........... 0

Open Shortest Path First commands are supported on the 
M4300 series switches only.

This section describes the commands you use to view and configure Open Shortest Path 
First (OSPF), which is a link-state routing protocol that you use to route traffic within a 
network. This section contains the following subsections:

Use this command to enter Router OSPF mode. 

Format

router ospf

Mode

Global Config