Netgear AirCard 598U (all others) 설치 가이드
Rev 2 Feb.11
19
12. In the “Installation completed successfully” window, click
Restart
.
13. After your computer restarts, configure the modem to use your account (if it
was not pre-activated), as described in
Removing the modem
To remove the modem:
1.
End your network connection (in Watcher, click
Disconnect
).
2.
Close Watcher if it is open.
3.
If a microSD card is inserted into the modem, ensure you've completed any
file transfers, and then eject the drive.
file transfers, and then eject the drive.
4.
Pull the modem out of the slot by gripping both sides of the modem and
pulling the modem straight out.
pulling the modem straight out.
Using the USB extension cable and laptop
clip
clip
Optionally, you can use the provided USB extension cable and laptop clip. The
laptop clip fits on top of your laptop screen and holds your modem. This allows
you to use your modem in crowded spaces.
laptop clip fits on top of your laptop screen and holds your modem. This allows
you to use your modem in crowded spaces.
Note: To meet FCC (regulatory) requirements, use only the supplied USB extension cable
and laptop clip; other cables and laptop clips should not be used.
and laptop clip; other cables and laptop clips should not be used.
To connect the USB extension cable and laptop clip:
1.
Remove the protective cap from the USB connector of the modem.
2.
Slide the modem into the laptop clip.
3.
Connect the USB extension cable to the modem.
4.
Insert the other end of the USB extension cable into the USB slot of your
computer.
computer.
When the modem and the cable are properly connected, the
LED indica-
tor is lit (blue, or blinking amber).
Modem
Laptop clip
USB extension cable