Netgear MBR1200 - HSPA+ Mobile Broadband Wireless Router 사용자 설명서

Basic Functioning

After you turn on power to the router, the following sequence of events should occur:

When power is first applied, verify that the Power 

 LED is on.

After approximately 10 seconds, verify that:

The Power LED is still solid green. A red light indicates the unit has failed its power-on 

self-test (POST).

The Internet LED is lit.

The Wi-Fi radio LED is lit. The Wi-Fi radio is on by default.

The Ethernet LAN port LED is lit when any local ports are connected.

If a LAN port’s LED is lit, a link has been established to the connected device. If a 
LAN port is connected to a 100 Mbps device, verify that the port’s LED is green. If the 
port is 10 Mbps, the LED is amber.

The Ethernet WAN port LED is lit when the router is connected to a wired modem.

The Signal LED is lit when the router has detected a mobile broadband signal.

A blue LED indicates excellent coverage.

A green LED indicates good coverage.

An amber LED indicates marginal coverage.

If any of these conditions does not occur, refer to the following table.

Power

Power LED is off.

Make sure that the power cord is correctly connected to your router and 

that the power supply adapter is correctly connected to a functioning 
power outlet. 

Check that you are using the power adapter supplied by NETGEAR for 

this product.

If the error persists, you have a hardware problem and should contact 
Technical Support.

Power LED is red.

There is a fault within the router. Try to clear the fault as follows:

Cycle the power to see if the router recovers.

Clear the router’s configuration to factory defaults. This sets the router’s 

IP address to 192.168.0.1. This procedure is explained in 

on page 97.

If the error persists, you might have a hardware problem and should contact 
Technical Support.