Netgear WNR2200 - N300 Wireless Router 설치 가이드

Installing Your Wireless Router Manually (Advanced and Linux Users)

15

•

LAN. At least one LAN light (1) should be lit. Green indicates that your computer is 
communicating at 100 Mbps; amber indicates 10 Mbps. If a LAN light is not lit, check that the 
Ethernet cable from the computer to the router is securely attached at both ends, and that the 
computer is turned on.

•

USB. The USB light (3) should be lit if a USB device is connected and ready to be used. 

•

WLAN On/Off. The Wireless Local Area Network (WLAN) button (5) turns the wireless 
function on and off.

•

WPS. The WPS button (6) turns the WPS function on and off. Be sure the WLAN button is 
turned on before turning on the WPS button.

When configuring your wireless router manually, you must log in to your N300 wireless router to 
set it up initially and to make any changes to your wireless router’s settings later.

Connect to the N300 wireless router by typing http://www.routerlogin.net in the address 
field of your browser, and then press Enter.

The factory default state is reset when you use the Restore Factory Settings button. 
See 

 for 

more information.

Connect to the N300 wireless router by typing any one of these three URLs in the 
address field of your browser, then pressing Enter: