Netgear WNR3500Lv1 - N300 Wireless Gigabit Router 설치 가이드

Troubleshooting

37

If the path is working, you see this message:

Reply from www.routerlogin.net: bytes=32 time=NN ms TTL=xxx 

If the path is not working, you see this message:

If the path is not working correctly, you could have one of the following problems:

•

Wrong physical connections

–

.

–

Check that the corresponding lights are on for your computer’s network interface card.

•

Wrong network configuration

–

Verify that the Ethernet card driver software and TCP/IP software are both installed and 
configured on your computer.

–

Verify that the IP addresses for your router and your computer are correct and that both 
addresses are on the same subnet (for example, 192.168.1.x/255.255.255.0).

After verifying that the path between your computer and the N300 Wireless router works correctly, 
test the path from your PC to the Internet. 

From the Windows task bar, click Start and select Run.

In the field provided, type cmd. A command screen will display.

At the > prompt, type the following:

ping -n 10 <IP address>

where <IP address> is the IP address of a remote device such as your ISP’s DNS server.

Press Enter.

If the path is working correctly, replies as in the previous section will display. If you do not receive 
replies:

•

Check that your PC has the IP address of your router listed as the default gateway. If the IP 
configuration of your PC is assigned by DHCP, this information will not be visible in your 
PC’s Network Control Panel. Verify that the IP address of the router is listed as the TCP/IP 
default gateway.