Netgear WNR2500 - N450 Wireless Router 사용자 설명서
genie ADVANCED Home
51
N450 Wireless Router WNR2500
Note:
If you change the LAN IP address of the router while connected
through the browser, you are disconnected. If this situation occurs,
you must open a new connection to the new IP address and log in
again.
through the browser, you are disconnected. If this situation occurs,
you must open a new connection to the new IP address and log in
again.
To change the LAN settings:
1.
Select ADVANCED > Setup > LAN Setup.
A screen similar to the following displays:
2.
Enter the settings that you want to customize.
51.
3.
Click the Apply button.
LAN Setup Screen Settings
The following settings are available in the LAN TCP/IP section:
•
IP Address. The LAN IP address of the router (by default, 192.168.1.1).
•
IP Subnet Mask. The LAN subnet mask of the router (by default, 255.255.255.0).
Combined with the IP address, the IP subnet mask allows a device to know which other
addresses are local to it, and which must be reached through a gateway or router.
Combined with the IP address, the IP subnet mask allows a device to know which other
addresses are local to it, and which must be reached through a gateway or router.
•
RIP Direction. Router Information Protocol (RIP) enables a router to exchange routing
information with other routers. This setting controls how the router sends and receives
RIP packets. Both is the default setting. With the Both or Out Only setting, the router
information with other routers. This setting controls how the router sends and receives
RIP packets. Both is the default setting. With the Both or Out Only setting, the router