Netgear WNR2200 - N300 Wireless Router 사용자 설명서

Troubleshooting

8-13

10. Make sure the Enable Wireless Router Radio check box is selected.

11. Click Setup Access List.

12. Make sure that the Turn Access Control On check box is not selected.

13. Configure and test your wireless computer for wireless connectivity.

Program the wireless adapter of your computer to have the same SSID and channel that you 
configured in the router, and disable encryption. Check that your computer has a wireless link 
and can obtain an IP address by DHCP from the router.

Once your computer has basic wireless connectivity to the router, you can configure the advanced 
wireless security functions of the computer and router (for more information about security, see 

This section explains how to restore the factory default configuration settings, changing the 
router’s administration password back to password. You can erase the current configuration and 
restore factory defaults in two ways:

•

).

•

Use the Reset button on the bottom of the router. Use this method for cases when the 
administration password or IP address is not known.

To restore the factory default configuration settings when you do not know the administration 
password or IP address, you must use the restore settings button on the bottom of the router.

1. Press and hold the restore settings button for over 5 seconds until the Power light turns to 

blinking amber.

2. Release the restore settings button, and wait for the router to reboot.

If the wireless router fails to restart, or the green Power light continues to blink, the unit might be 
defective. If the error persists, you might have a hardware problem and should contact Technical 
Support at 

.