Netgear WNR2200 - N300 Wireless Router 사용자 설명서

Safeguarding Your Network

2-2

–

The wireless radio frequency (2.4GHz or 5GHz) that each wireless adapter supports.

–

Wireless security option. To successfully implement wireless security, check each 
wireless adapter to determine which wireless security option it supports. 

See 

•

Push 'N' Connect (WPS) automatically implements wireless security on the wireless router 
while, at the same time, allowing you to automatically implement wireless security on any 
WPS-enabled devices (such as wireless computers and wireless adapter cards). You activate 
WPS by pressing a WPS button on the wireless router, clicking an onscreen WPS button, or 
entering a PIN number. This generates a new SSID and implements WPA/WPA2 security.

To set up your wireless network using the WPS feature:
–

Use the WPS button on the side of the wireless router (there is also an onscreen WPS 
button), or enter the PIN of the wireless device. 

–

Make sure that all wireless computers and wireless adapters on the network are 

Wi-Fi 

certified and WPA or WPA 2 capable, and that they support WPS configuration.

See 

.

The range of your wireless connection can vary significantly based on the physical placement of 
the wireless router. The latency, data throughput performance, and notebook power consumption 
of wireless adapters also vary depending on your configuration choices.

For best results, place your wireless router according to the following guidelines:

•

Near the center of the area in which your PCs will operate.

•

In an elevated location such as a high shelf where the wirelessly connected PCs have line-of-
sight access (even if through walls).

•

Away from sources of interference, such as PCs, microwave ovens, and 2.4 GHz cordless 
phones.

•

Away from large metal surfaces.

Note: NETGEAR’s Push 'N' Connect feature is based on the Wi-Fi Protected Setup 

(WPS) standard (for more information, see 

Fi-certified and WPS-capable products should be compatible with NETGEAR 
products that implement Push 'N' Connect.