Netgear WNR1000v1 - Wireless- N Router 사용자 설명서

Safeguarding Your Network

2-17

You can add WPS-enabled and non-WPS-enabled client devices.

To add an additional wireless client device that is WPS enabled:

1. Follow the procedures in 

2. For information about how to view a list of all devices connected to your router (including 

wireless and Ethernet-connected), see 

.

If you are connecting a combination of WPS-enabled clients and clients that are not WPS enabled, 
you cannot use the WPS setup procedures to add clients that are not WPS enabled.

To connect both non-WPS-enabled and WPS-enabled clients to the N150 Wireless Router:

1. Configure the settings of the N150 Wireless Router (shown in the Wireless Settings screen) for 

WPA-PSK or WPA2-PSK security, and record that information. See 

.

When you change security settings, all existing connected wireless clients that do not share 
those settings are disassociated and disconnected from the router.

2. For the non-WPS-enabled devices that you wish to connect, open the networking utility, and 

follow the utility’s instructions to enter security settings.

3. For the WPS-enabled devices that you wish to connect, follow the procedures in 

. 

The N150 Wireless Router automatically preserves the settings you configured in 

 so all 

clients share the same security settings (for more information, see 

).

Note: Your wireless settings do not change when you add an additional WPS-enabled 

client unless you have cleared the Keep Existing Wireless Settings check box (in 
the Wireless Settings screen). If you do clear the check box, a new SSID and a 
passphrase are generated, and all existing connected wireless clients are 
disassociated and disconnected from the router.