KitchenAid 36'' Under-the-Cabinet 600 CFM Architect® Series II 설치 가이드

4. Use saber or keyhole saw to cut the circular vent opening.

1. Install vent through the vent opening in upper cabinet or wall. 

Complete venting system according to the selected venting 
method. See “Venting Requirements” section. 

2. Use caulking to seal exterior wall or roof opening around the 

cap.

Install Range Hood

1. Remove the grease filters. See the “Range Hood Care” 

section.

2. Remove mounting screws and lateral supports.

■

Depending on your installation, remove either top or rear 
rectangular vent knockout.

NOTE: Do not remove rectangular knockouts if 
installation of range hood is to be non-venting 
(recirculating).

■

Make sure damper pivot is nearest to top/back edge of 
range hood. 

■

Remove tape from damper flap.

NOTE: The exhaust adapter/damper can be installed up 
to 1" (2.5 cm) on either side of the hood center to 
accommodate off-center ductwork.

■

If using rectangular vent, attach rectangular damper/vent 
connectors to the range hood using sheet metal screws.

■

If using round vent, attach vent transition piece 
(purchased separately) to range hood top using sheet 
metal screws.

NOTE: If the wall cap is directly behind the vent 
connector, the dampers in the connector and wall cap 
must not interfere with each other. Remove the vent 
connector damper if they interfere.

3. Lift the range hood up under cabinet and determine final 

location by centering beneath cabinet. Mark on the underside 
of cabinet the location of the 4 keyhole mounting slots on the 
range hood. Set range hood aside on a covered surface.

4. Use 

¹⁄₈" (3 mm) drill bit and drill 4 pilot holes as shown.

5. Install the 4 - 4.5 x 13 mm mounting screws in pilot holes. 

Leave about 

¹⁄₄" (6.4 mm) space between screw heads and 

cabinet to slide range hood into place.

B

A

A

C

E

B

A

B

D

A

A