KitchenAid 36'' Under-the-Cabinet 600 CFM Architect® Series II 설치 가이드

RANGE HOOD USE

The range hood is designed to remove smoke, cooking vapors 
and odors from the cooktop area. For best results, start the hood 
before cooking and allow it to operate several minutes after the 
cooking is complete to clear all smoke and odors from the 
kitchen.

The hood controls are located on the center of the range hood.

Display

After 30 hours of fan function, the display will show “Clean 
Grease Filter” when the fan is active. When this icon shows in the 
display, the installed grease filters should be washed. See the 
“Range Hood Care” section.

■

To reset the grease filter saturation alarm, press and hold the 
Power Increase button for 5 seconds. The “Clean Grease 
Filter” icon will no longer be displayed.

After 120 hours of fan function, the display will show “Replace 
Charcoal Filter” when the fan is active. When this icon shows in 
the display, the charcoal filters should be replaced. See the 
“Range Hood Care” section.

■

To reset the charcoal filter saturation alarm, press and hold 
the Power Decrease button for 5 seconds. The “Replace 
Charcoal Filter” icon will no longer be displayed.

The audible signals can be activated or deactivated by pressing 
the “Light” button for 5 seconds.

■

If the audible signal is activated, a tone will sound, and “Snd” 
symbol will appear in the display for 3 seconds.

■

If the audible signal is deactivated, the “Snd” symbol will 
appear on the display for 3 seconds.

When the charcoal filter is in use (recirculating mode), press and 
hold the Power Decrease and Power Increase buttons at the 
same time for 5 seconds. “Able” will appear in the display for 
3 seconds. 

If the charcoal filter is not used (vented mode), press and hold the 
Power Decrease and Power Increase buttons at the same time 
for 5 seconds. “None” will appear in the display for 3 seconds. 

■

When the charcoal filter has been excluded, the charcoal filter 
alarm is disabled.

■

The inclusion or exclusion of the charcoal filter must be 
selected while the lights and the fan motor are Off.

The control is equipped with a heat sensor that will turn on the 
blower to the highest speed if excessive heat occurs around the 
control area.

■

If the blower is On or Off, the blower will automatically set to 
the highest speed. “Auto” will appear in the display to 
indicate that the heat sensor has detected excessive heat.

■

When the blower is operating due to excessive heat detected 
by the heat sensor, the blower speed cannot be decreased.

■

When the temperature level on the hood drops to normal, the 
blower will return to its setting before the excessive heat was 
sensed.

Light

1. Press the Light button to turn the light on to High.

2. Press the Light button again to turn the light to Low.

3. Press the Light button a third time to turn the light Off.

B

C

D

A

A

B

C

D

E