Xerox DocuColor 12 Printer with Fiery EX12 사용자 가이드
DOCUCOLOR 12 USER GUIDE
2–21
GETTING TO KNOW YOUR DOCUCOLOR 12
1
2
3
4
5
6
7
Ground fault protection
The DocuColor 12 copier/printer is equipped with
a safety feature called a Ground Fault Protector,
Figure 18. This device removes all electrical
power to the copier/printer if a fault is detected in
the power supply to the copier/printer.
a safety feature called a Ground Fault Protector,
Figure 18. This device removes all electrical
power to the copier/printer if a fault is detected in
the power supply to the copier/printer.
If power is interrupted to the copier/printer,
perform the following:
perform the following:
1
Locate the Ground Fault Protector on the back of
the copier/printer in the lower left corner.
the copier/printer in the lower left corner.
2
Flip the switch up if the device has been tripped
and the switch is in the Off (down) position.
and the switch is in the Off (down) position.
If the device interrupts power to the copier/printer
again, or if power has not been restored by the
above procedure, call your Xerox service
representative.
again, or if power has not been restored by the
above procedure, call your Xerox service
representative.
CAUTION: The Fuser Roll remains in a cammed-
up position if power to the copier/printer is
interrupted while the copier/printer is in use. If the
Fuser Roll remains in the cammed-up position for
a prolonged period of time, the Fuser Roll can be
damaged and copy quality defects can occur. To
prevent any damage, the copier/printer should be
powered on and a copy/print made as soon as the
power is restored. The Fuser Roll will not be
released from the cammed-up position until the
power is restored, the Power Switch is in the On
position, and the Start button is pressed again.
up position if power to the copier/printer is
interrupted while the copier/printer is in use. If the
Fuser Roll remains in the cammed-up position for
a prolonged period of time, the Fuser Roll can be
damaged and copy quality defects can occur. To
prevent any damage, the copier/printer should be
powered on and a copy/print made as soon as the
power is restored. The Fuser Roll will not be
released from the cammed-up position until the
power is restored, the Power Switch is in the On
position, and the Start button is pressed again.
Figure 18: Ground Fault Protector