Honeywell UV Treatment System (UV100) 제품 데이터시트

68-0262—06

4

When installed next to the cooling coil, the Surface Treatment 

System prevents a high percentage of the growth of 

micro-organisms such as mold that may grow on duct 

surfaces, coils and drain pans. Individual results depend on 

careful installation and maintenance. See. Fig. 2. 

NOTE: When the installer is uncertain about whether the drip 

pan in the installation can tolerate UV exposure, 

consult the UV exposure white paper, form no. 

50-8788, at hbctechlit.honeywell.com Web site.

1. Choose a location that is readily accessible for regular 

inspection and cleaning. Fig. 1 and 2 and show possible 

mounting locations.

2. Allow clearance in front of the device for removing the 

lamp assemblies. Fig. 3 shows lamp assembly lengths.

3. Be sure depth can accommodate full length of UV lamp 

for your model as shown in Fig. 3.

4. Be sure duct mounting location is 8 in. wide minimum.

5. Be sure 120 Vac electrical outlet is within range of unit to 

plug in the power cord.

6. Select single-lamp and dual-lamp air treatment system 

location on HVAC return air duct that is easily accessible 

with a flat mounting surface. Select surface treatment 

system location on HVAC supply air duct that is easily 

accessible with a flat mounting surface; locate the unit so 

the lamp can surround the evaporator coil and drip pan 

with ultraviolet light.

7. Mount to allow correct operation:

a. Do not mount upside down.

b. Do not mount with lamps facing up.

Be careful when inserting ultraviolet device into sheet 

metal cutout.

Wear protective gloves when working near sheet metal.

Use the following instructions to mount the UV System on the 

air duct of an HVAC system:

1. Disconnect power to the HVAC system before installing 

the UV System.

2. Select the appropriate template for your model (see Fig. 

18-20).

3. Place the appropriate template for your model on the 

duct surface, centering the bulb hole(s) on the duct. 

4. Mark the location on the duct for 2 in. diameter bulb 

hole(s), unit mounting-screw pilot holes, and when 

installing a return air model, the 1-1/2 in. airflow sensor 

hole.

5. Cut 2 in. bulb hole(s) and 1-1/2 in. airflow sensor hole in 

the duct. Remove any burrs. Note that the airflow sensor 

6. Use a 3/32 in. drill for pilot holes for mounting screws.

7. Be sure duct surface is flat after all holes are drilled.

8. Position entire base unit on duct. Be sure bulb and 

9. Install unit into duct using three (or two, depending on 

model) no.10, 2 in. Phillips head sheet metal mounting 

screws provided. (A spare screw is provided for three-

screw model.)

10. Tighten screws to 12 to 14 in.-lb so space between case 

and duct is sealed.

M22859

Veuille

z lire e

t bien

 comp

rendre

 

l’insta

llation

 et la m

ainten

ance.

Veuille

z lire et bie

n compr

endre 

l’instal

lation et

 la ma

intenanc

e.