Husqvarna 143 R II (9666572-02 + 9673317-01) 사용자 설명서

English

 –

 65

Connect the engine (A) to the tube (B) with four screws 
(C).

•

Fit the handlebar in the handlebar clamp on the shaft 
using four screws.

•

Fit the protective sleeve as shown in the diagram.

1 Remove the air filter cover.
2 Insert the throttle cable (A) through the carburettor 

bracket (B), then screw the cable adjuster sleeve (C) 
into the carburettor bracket fully.

3 Position the slotted fitting (D) on the carburettor so the 

recessed hole (E) for the cable lug (F) is away from the 
cable adjuster sleeve.

4 Rotate the carburettor throttle cam and slip the throttle 

cable through the slot in the slotted fitting, making 
sure the cable lug drops into the recessed hole.

5 Operate the throttle trigger a few times to make sure 

that it works correctly.

6 Adjust the cable adjuster sleeve so the stop on the 

carburettor throttle cam just contacts the throttle stop 
and the cable position keep 1-2 mm play between the 
cable lug and the slotted fitting when the throttle 
trigger is fully depressed.

7 When the throttle cable is adjusted correctly, tighten 

the locking nut (G).

1-2mm

H1153399-45,143RII.fm  Page 65  Tuesday, April 15, 2014  7:58 AM