Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) 릴리즈 노트
3
Release Notes for Cisco ONS 15454 Release 8.5.3
OL-17923-01
Caveats
CSCsj88469—Protect port of the Y-cable protected MXP-MR-10DME cards report SYNCLOSS alarm
as Minor instead of Major
as Minor instead of Major
The protect port of the Y-cable protected MXP-MR-10DME cards report SYNCLOSS alarm as Minor
instead of Major. This issue will be resolved in a future release.
instead of Major. This issue will be resolved in a future release.
CSCsj97288—PROV-MISMATCH alarm is raised on TXP_MR_10E card
The PROV-MISMATCH alarm is raised on TXP_MR_10E cards when a port with an ONS-XC-10G-L2
pluggable port module (PPM) is provisioned for ZR reach for 10GE. This issue will be resolved in a
future release.
pluggable port module (PPM) is provisioned for ZR reach for 10GE. This issue will be resolved in a
future release.
CSCsk15712—Trunk port of the Y-cable protected TXP-MR-2.5G card raises LOS-P alarm in critical
state
state
The trunk port of the Y-cable protected TXP-MR-2.5G card raises an LOS-P alarm when the port is in
Critical state. The workaround is to change the port status to OOS,DSBLD, which causes the LOS-P
alarm to downgrade from Critical state to Minor. This issue will be resolved in a future release.
Critical state. The workaround is to change the port status to OOS,DSBLD, which causes the LOS-P
alarm to downgrade from Critical state to Minor. This issue will be resolved in a future release.
CSCsl04155—Transient alarms occur when upgrading the software
Transient alarms occur under the following conditions:
•
When upgrading the software from Cisco ONS Release 4.x, 5.x, 6.x, and 7.x to Cisco ONS
Release 8.5, the PMI and FDI alarms are raised. These alarms disappear after all the nodes of the
network are upgraded to Cisco ONS Release 8.5.
Release 8.5, the PMI and FDI alarms are raised. These alarms disappear after all the nodes of the
network are upgraded to Cisco ONS Release 8.5.
•
When upgrading the software from Cisco ONS Release 8.0 to Cisco ONS Release 8.5, the PMI, FDI,
and APC-CORR-SKIP alarms are raised. These alarms disappear after all the nodes of the network
are upgraded to Cisco ONS Release 8.5.
and APC-CORR-SKIP alarms are raised. These alarms disappear after all the nodes of the network
are upgraded to Cisco ONS Release 8.5.
This issue will be resolved in a future release.
CSCsl57383—OPWR_LFAIL and OPWR_HFAIL alarms does not correlate the downstream alarms
The OPWR_LFAIL and OPWR_HFAIL alarms do not properly correlate the downstream alarms when
Multipath Optical (MPO) ribbon is connected to the ADD port is removed from the ADD circuit passing
through the WXC card. This issue will be resolved in a future release.
Multipath Optical (MPO) ribbon is connected to the ADD port is removed from the ADD circuit passing
through the WXC card. This issue will be resolved in a future release.
CSCsm00488—SYNCLOSS alarm is raised on a Y-cable switch
A SYNCLOSS alarm is raised for a long time on a Y-cable switch when switching back to a working
card after an WTR alarm is cleared for MXP-MR-10DME cards. This issue will be resolved in a future
release.
card after an WTR alarm is cleared for MXP-MR-10DME cards. This issue will be resolved in a future
release.
CSCsm12542—LOS-P alarm is reported in Critical severity on a Y-cable protected MXP-MR-10DME
card
card
An LOS-P alarm is reported in Critical severity on a Y-cable protected MXP-MR-10DME card even
when it is in standby mode. This issue will be resolved in a future release.
when it is in standby mode. This issue will be resolved in a future release.