Cisco Cisco ONS 15310-MA SONET Multiservice Platform 설치 가이드
6
Upgrading the Cisco ONS 15310-MA to Release 7.2
78-17822-01
DLP- U263 Verify CTC Workstation Requirements
Stop. You have completed this procedure.
NTP-U174 Upgrade to Software R7.2
Step 1
Insert the Release 7.2 software CD into the workstation CD-ROM (or otherwise acquire access to the
software) to begin the upgrade process.
software) to begin the upgrade process.
Note
Inserting the software CD activates the CTC Setup Wizard. You can use the setup wizard to
install components or click Cancel to continue with the upgrade.
install components or click Cancel to continue with the upgrade.
Caution
Do not perform maintenance or provisioning activities during the activation task.
Caution
When managing end-to-end circuits participating in an ML-series RPR ring across multiple nodes
involved in a parallel upgrade, all nodes participating in these circuits must have completed the
activation before the end-to-end traffic will resume.
involved in a parallel upgrade, all nodes participating in these circuits must have completed the
activation before the end-to-end traffic will resume.
Step 2
Complete the
for all nodes (or groups of 8
or less nodes) you are upgrading.
Step 3
Complete the
for all nodes you are upgrading.
Note
You can only activate one node at a time; however, you can begin activation of the next node as
soon as the controller cards for the current node have rebooted successfully (wait five minutes
from the time the SYSBOOT alarm is raised).
soon as the controller cards for the current node have rebooted successfully (wait five minutes
from the time the SYSBOOT alarm is raised).
Step 4
(Optional) If you wish to ensure that a software revert to the previous software release will no longer be
possible, complete the
possible, complete the
for all nodes, or
groups of nodes you are upgrading a second time.
Caution
If you download the Release 7.2 software a second time following activation you will never be able to
revert to the previous software version.
revert to the previous software version.
Step 5
Complete the
(any nodes not using SNTP).
Purpose
This procedure upgrades your CTC software to Software R7.2.
Tools/Equipment
PC or UNIX workstation
Prerequisite Procedures
Required/As Needed
Required
Onsite/Remote
Onsite or remote (but in the presence of the workstation)
Security Level
Superuser