Cisco Cisco 1 GHz GainMaker Amplifier 설치 가이드
Installing the Power Supply
3 Tighten the four module screws on the power supply module to 2 ft-lb to 5 ft-lb
(2.7 Nm to 6.8 Nm).
4 Attach the 10-pin keyed connector of the power cable and harness to the power
supply module.
Note: The 10-pin keyed connector can be connected one way only. Be sure that
the connector is installed securely to the power supply board.
5 Proceed to
To Set the AC Undervoltage Lockout Selector (on page 25).
To Set the AC Undervoltage Lockout Selector
Set the AC undervoltage lockout selector for your powering application as specified
by your system engineering guidelines.
Undervoltage Lockout Setting
Application
30 V Lockout
60 VAC System
40 V Lockout
90 VAC System
50 V Lockout
90 VAC System
OL-31156-01
25