Cisco Cisco Industrial Wireless 3702 Access Point 릴리즈 노트

On access points running Cisco IOS software, you can also find the software release on the System 
Software Version page in the access point’s web-browser interface. If your access point does not run 
Cisco IOS software, the software release appears at the top left of most pages in the web-browser 
interface. 

To upgrade your access point or bridge software, follow these steps:

Follow this link to the Cisco home page:

Click Support. The Support and Documentation page appears.

Under the Select a Product Name, click Wireless. The Product/Technology Support page appears.

Under the Make a Selection to Continue section, click Access Point. Products and Access Point are 
highlighted.

Select the access point model for which you need the information. For example, click the Cisco Aironet 
1600 series. A list of documents appears.

Click Configure. A list of configuration documents appears.

Click Cisco IOS Software Configuration Guide for Cisco Aironet Access Points, 15.3(3)JC. 

Navigate to the Managing Firmware and Software chapter.

For information on Cisco IOS software, click this link to browse to the Cisco IOS Software Center on 
Cisco.com: 

The new Cisco IOS software is supported only in these versions of 1550 series:

AP 1550 does not support 64 MB Cisco IOS Release starting from 15.2(4)JA1 in autonomous mode.

You can convert an access point from lightweight mode back to autonomous mode by loading a Cisco 
IOS Release that supports autonomous mode. If the access point is associated with a controller, you can 
use the controller to load the Cisco IOS release. If the access point is not associated with a controller, 

1552E

VID 04

1552EU

VID 01 (all)

1552I

VID 03

1552H

VID 04

1552S

VID 01 (all)