Cisco Cisco Industrial Wireless 3702 Access Point 릴리즈 노트

Release Notes for Cisco Aironet Access Points for Cisco IOS Release 15.3(3)JC

System Requirements

you can load the Cisco IOS release using TFTP. The image files and their supported access points are
listed in

Note

Conversions from an 8.0 Wireless LAN Controller unified release AP image to autonomous 15.3(3)
k9w7 image will get aborted with a message "AP image integrity check failed." To overcome this, load
any previous autonomous k9w7 image and then upgrade to the 15.3(3) JAB k9w7 images. For more
information, see caveat CSCuq53889.

Disabling Radios to Prevent Unexpected Reboots When Upgrading the System Software

If your access point runs Cisco IOS Release 12.2(11)JA, 12.2(11)JA1, or 12.2(11)JA2, your access point
might unexpectedly reboot after you upgrade to a later Cisco IOS release. However, after the access point
reboots, the upgrade is complete and the access point operates normally. It is recommended to disable
the radio interfaces before upgrading the software to prevent the access point from rebooting
unexpectedly.

To disable the radio interfaces using the access point’s web-browser interface, which you can access
through the access point's Ethernet port, follow these steps:

Step 1

Browse to the Network Interfaces: Radio Settings page.

Figure 1

shows the top portion of the Network

Interfaces: Radio Settings page.

Table 1

Image File Names

Image File

Supported Access Points

Ap3g2

1700I, 2700I/2700E, 2600I/2600E, 3600I/3600E,
3700I/3700E

Ap3g1 3500I/3500E,

1260I/1260E

Ap1g1 702I

Ap1g3 1530I/1530E

Ap1g2 1600I/1600E

1570

1572IC, 1572EC, 1572EAC

1520

1552E, 1552EU, 1552S, 1552I, 1552H, 1552C, 1552 CU

1140

1040 and c1140