Cisco Cisco Web Security Appliance S390 사용자 가이드
Chapter 3 Deployment
Connecting the Appliance to a WCCP Router
3-10
Cisco IronPort AsyncOS 7.1 for Web User Guide
OL-23207-01
describes each part of the WCCP configuration syntax for enabling
WCCP on the router.
You can also configure a WCCP router to perform other tasks, such as the
following:
following:
Table 3-1
WCCP Router Configuration Syntax for Enabling the Router
WCCP Configuration
Description
ip wccp version 2
Defines the version of WCCP to use on the router.
You must specify version 2 to work with the Web
Security appliance.
You must specify version 2 to work with the Web
Security appliance.
This command is required.
ip wccp
service_group
password
password
Specifies a service group to enable on the router. It
also enables the WCCP service on the router.
also enables the WCCP service on the router.
This command is required.
interface
interface_type_number
Specifies an interface to configure and enters
interface configuration mode. Enter the interface
number for the interface_type_number variable.
interface configuration mode. Enter the interface
number for the interface_type_number variable.
This command is required.
ip wccp
service_group
redirect
direction
Enables WCCP redirection on the specified
interface.
interface.
Enter one of the following values for the direction
variable:
variable:
•
in. Use
in
when you want the router to redirect
packets as they enter the router.
•
out. Use
out
when you want the router to
redirect packets right before they leave the
router.
router.
This command is required.
ip wccp
service_group
password
password
Sets a password on the router for the specified
service group.
service group.
This command is only required when the WCCP
service defined on the appliance has password
security enabled.
service defined on the appliance has password
security enabled.