Cisco Cisco TelePresence Video Communication Server Expressway
Configuring the Cisco VCS
Cisco VCS Deployment Guide: Microsoft OCS 2007 R2, Lync 2010, Cisco VCS X7.0
and Cisco AM GW 1.0, 1.1
and Cisco AM GW 1.0, 1.1
Page 10 of 30
Specify the Cisco AM GW zone: Non-B2BUA mode
This is where you select the Cisco AM GW zone to use, and decide whether to set up policy rules to
control which calls can use the Cisco AM GW.
control which calls can use the Cisco AM GW.
1. Go to the
Advanced Media Gateway configuration
page (
VCS configuration > Advanced
Media Gateway > Configuration
).
2. Configure the fields as follows:
Advanced Media
Gateway zone
Gateway zone
Select the zone that you configured for the Cisco AM GWs
e.g. “To AM Gateway”
e.g. “To AM Gateway”
Policy mode
By default (where Policy mode is Off) all calls to or from OCS/Lync are sent
via the selected Cisco AM GW zone. If you want to limit which calls go via the
Cisco AM GW, set the Policy mode to On and then set up policy rules to deny
via the selected Cisco AM GW zone. If you want to limit which calls go via the
Cisco AM GW, set the Policy mode to On and then set up policy rules to deny