Cisco Cisco TelePresence Video Communication Server Expressway
Endpoint configuration
(those that can initiate a Multiway™ conference)
Endpoint configuration
(those that can initiate a Multiway™ conference)
E20
E20 must be running TE 1.0 or later code
E20 supports SIP only
To configure Multiway™:
1. Go
1. Go
to
Settings > System Settings > Administrator settings > Advanced settings > SIP >
Profile 1.
2. Set
MultiWayConference = the Conference Factory Alias as set up on the Cisco VCS.
MXP – F Series
MXP must be running F8.0 or later code
F8.1 or later is recommended for mixed H.323 and SIP Multiway™ conferences
F8.2 or later is recommended if TLS is used to connect the MCU and Cisco VCS.
You can configure Multiway™ through either a web browser or from the MXP itself.
To configure Multiway™ through a web browser:
1. Enter the IP address of the MXP into the web browser.
1. Enter the IP address of the MXP into the web browser.
2. Go
to
Endpoint configuration > General.
3. Scroll to the bottom of page (MultiPoint Call Options).
4. Set
Multi point to Multiway.
5. Set
Multiway URI = the Conference Factory Alias as set up on the Cisco VCS.
To configure Multiway™ on the MXP itself:
1. Go
1. Go
to
Control panel (spanner) > General > Multipoint call options.
2. Set
Multi point to Multiway.
3. Set
Multiway URI = the Conference Factory Alias as set up on the Cisco VCS.
Note:
If Multiway URI is configured with “sip:” at the start, e.g. sip:multiway@domain then the MXP will
request the Multiway™ conference call using SIP.
If there is no “sip:” at the start of the Multiway URI, e.g. multiway@domain then the MXP will
request the Multiway™ conference call using H.323. (For clarity if you want to force the
Multiway™ conference call request to use H.323, an “h323:” can be put at the start of the
Multiway URI.)
request the Multiway™ conference call using SIP.
If there is no “sip:” at the start of the Multiway URI, e.g. multiway@domain then the MXP will
request the Multiway™ conference call using H.323. (For clarity if you want to force the
Multiway™ conference call request to use H.323, an “h323:” can be put at the start of the
Multiway URI.)
The Multiway URI must be in the format [sip:|h323:]name@domain, e.g. multiway@domain or
h323:multiway@domain for H.323 or sip:multiway@domain for SIP.
h323:multiway@domain for H.323 or sip:multiway@domain for SIP.
Two additional advanced parameters are available on the command line interface:
xconfiguration Multipoint MultiwayMultiprotocol: On|Off
On allows the “Join” button when one call is H.323 and the other is SIP
Off only allows the “Join” button if both calls are the same protocol
Cisco VCS Deployment Guide: Multiway™ (Cisco VCS X5)
Page 14 of 25