Cisco Cisco TelePresence Video Communication Server Expressway
Add an X7.0.n VCS to a VCS X7.0.n cluster (n is the same value on all peers)
Cisco VCS Deployment Guide: Cluster creation and maintenance (Cisco VCS X7.0.n)
Page 29 of 63
2. Repeat for all Cisco VCS peers in the cluster.
After adding the Cisco VCS peer to the cluster
If Cisco TMS is being used, verify the correct operation of TMS Agent by running TMS agent
diagnostics:
diagnostics:
1. Log into Cisco TMS.
2. Go to Administrative Tools > TMS Agent Diagnostics.
3. In the TMS Agent Browser panel on the left side of the page, select Local TMS Agent.
4. Click Run All Diagnoses to run the diagnostic tests on the Local TMS Agent.
5. For each Cisco VCS peer:
a. In the TMS Agent Browser panel on the left side of the page, expand the Clustered VCSs
folder and cluster folder and select the Cisco VCS peer.
b. Click Run All Diagnoses to run the diagnostic tests on the VCS peer.
Note: If authentication is intentionally enabled on the Cisco VCS, ignore the warning ‘verify that
authentication is disabled on the VCS’.
authentication is disabled on the VCS’.
If all tests are successful (all green check marks), proceed with the “Additional cluster
configuration” instructions below.
configuration” instructions below.
If any errors are found (a red ‘X’ will appear against failing tests), do not proceed further with this
upgrade, but contact your Cisco Authorized Service Provider for further assistance to resolve the
issues identified.
upgrade, but contact your Cisco Authorized Service Provider for further assistance to resolve the
issues identified.
Additional cluster configuration
If Conference Factory (Multiway™) is to be used, see the section “Conference Factory
(Multiway™)” in “Appendix 4 – Impact of clustering on other Cisco VCS applications”.
(Multiway™)” in “Appendix 4 – Impact of clustering on other Cisco VCS applications”.
If the cluster has non-default Trusted CA certificate and / or non default Server certificate ensure
that the added peer is configured with the required Trusted CA certificate and an appropriate
Server certificate.
that the added peer is configured with the required Trusted CA certificate and an appropriate
Server certificate.
Add an X7.0.n VCS to a VCS X7.0.n cluster is now complete.