Cisco Cisco D9824 Advanced Multi Decryption Receiver 설치 가이드

 

192 

78-4039426-01 Rev D 

1  From the user interface of the D9824, click System Settings > System > 

Time/Clock. The Time/Clock page is displayed. 

 

2  Set the Date Format of the receiver. The following formats are supported: 

YYYY_MM_DD, DD_MM_YYYY, MM_DD_YYYY. 

3  Set the Time Format of the receiver. Current time information is normally 

broadcast as part of the transmitted digital signal. It is broadcast as GMT 
(Greenwich Mean Time) with date information in Modified Julian Date format. 
The following formats are supported: 24Hr, 24 Hr SuspendZero (the leading zero 
is dropped from the time), 12Hr, 12Hr SuspendZero (the leading zero is dropped 
from the time). 

4  Set the GMT Offset. The local time is displayed using a time zone (GMT offset). 

If your local time is not GMT, you must set this time setting in the range from -
12.0 to +12.0 hours in 0.5 hour increments. 

5  The Current TDT Time/Date displays the current TDT (Time and Date Table) 

date and time received from the DVB stream. This is displayed as local time. 

6  Select Enable NTP Time Service to periodically request NTP (Network Time 

Protocol) timestamps from the NTP server (NTP server address set below) and to 
synchronize its system (i.e., non-DVB related) time with the NTP server. This is 
displayed as local time. 

7  Set the NTP Server Address. If the NTP server address is not set (0.0.0.0), the 

IRD will not attempt to connect to the server.  

8  Displays the current time in the Current NTP Time/Date if IRD receives a valid 

reply from the NTP server, adjusted for local time zone.  

9  Click Apply.