Cisco Cisco D9824 Advanced Multi Decryption Receiver 설치 가이드
Configuring System Settings
78-4039426-01 Rev D
195
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the alarm is disabled (Enb is set to No).
being suppressed because the alarm is disabled (Enb is set to No).
8 If current alarm is enabled, set Relay to Yes for the rear panel alarm relay to be
triggered when the alarm is set or cleared.
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the alarm is disabled (Enb is set to No).
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the alarm is disabled (Enb is set to No).
9 Click Apply.
To Set Up Warnings
1 From the Setup - Alarm Setup page, click on the Warning Setup link at the
1 From the Setup - Alarm Setup page, click on the Warning Setup link at the
bottom left hand corner of the page. The Setup - Warning Setup page is
displayed.
displayed.
2 Select Enable Alarm/Warning Front Panel Reminder and the warning flashes on
the LCD display for a two-second interval every 10 seconds. The warning will
continue to flash periodically until it is either cleared or the Enable
Alarm/Warning Front Panel Reminder is de-selected.
continue to flash periodically until it is either cleared or the Enable
Alarm/Warning Front Panel Reminder is de-selected.
3 The Warning Setup section displays a list of the warning messages. For more
information on warning messages, refer to Messages (see "D9824 Alarm
Messages" on page 222).
Messages" on page 222).
4 Set Enable/Disable to Yes and the warning message will be reported. Set to No
and the warning is disabled and the Relay and Trap settings are ignored.
Note: Enable/Disable must be set to Yes for the Relay and Trap settings to be
functional.
Note: Enable/Disable must be set to Yes for the Relay and Trap settings to be
functional.