Cisco Cisco TelePresence Video Communication Server Expressway
Enabling endpoints registered on the Cisco VCS Control to call endpoints registered on CUCM
Cisco VCS Deployment Guide: CUCM v6.1, 7 and 8 with Cisco VCS X5.1 using a SIP trunk
Page 21 of 50
4. Configure the fields as follows:
H.323 mode
Off
H.323 access is not required for communication with CUCM
H.323 access is not required for communication with CUCM
SIP mode
On
SIP port
5060
If the SIP access port on CUCM is not 5060, change the SIP Port value
to be the same as used by CUCM
to be the same as used by CUCM
Transport
TCP
TLS verify mode
Off
Authentication
trust mode
trust mode
Off
Accept proxied
registrations
registrations
Deny
Peer 1 address
IP address of CUCM, or the domain of CUCM
Zone profile
(Advanced section)
(Advanced section)
Select Cisco Unified Communications Manager.
See ‘Appendix 9 – Advanced parameters set by the “Cisco Unified
Communications Manager” zone profile’ for details on what is configured
by this setting.
Communications Manager” zone profile’ for details on what is configured
by this setting.
5. Click Create zone.
Create a search rule to route calls to the CUCM neighbor zone
1. Go to VCS Configuration > Search rules > Rules.
2. Click New.
Note: Search rules are used to specify the range of telephone numbers / URIs that will be handled by
this neighbor CUCM. Search rules can also be used to transform URIs before they are sent to the
neighbor.
In this implementation the transforms set up in the “Create transforms” section above have already
made sure that dial strings are in URI format number@vcs.domain. As CUCM requires dialed
numbers to be in the form 3xxx@<IP address of CUCM> a transform will be required to convert calls
to CUCM which are addressed 3xxx@vcs.domain to that format.
this neighbor CUCM. Search rules can also be used to transform URIs before they are sent to the
neighbor.
In this implementation the transforms set up in the “Create transforms” section above have already
made sure that dial strings are in URI format number@vcs.domain. As CUCM requires dialed
numbers to be in the form 3xxx@<IP address of CUCM> a transform will be required to convert calls
to CUCM which are addressed 3xxx@vcs.domain to that format.