Cisco Cisco TelePresence Video Communication Server Expressway
Enabling Lync clients registered on Lync Server to call endpoints registered on the video network
Cisco VCS Deployment Guide: Microsoft Lync 2010 and Cisco VCS X6.1
Page 39 of 81
Enabling Lync clients registered on Lync
Server to call endpoints registered on the video
network
Server to call endpoints registered on the video
network
“Lync gateway” Cisco VCS Control configuration
1. Configure the “Lync gateway” Cisco VCS with a neighbor zone that contains the video network.
2. Set up one or more Search rules to route calls with video network domains to the video network.
Note: In small test and demo networks this configuration is not necessary as the video network Cisco
VCS is the “Lync Gateway” Cisco VCS. You can skip this section and go to “Lync configuration” on
page 41.
VCS is the “Lync Gateway” Cisco VCS. You can skip this section and go to “Lync configuration” on
page 41.
Configure the “Lync gateway” Cisco VCS with a neighbor zone that
contains the video network
contains the video network
1. Go to the Zones page (VCS configuration > Zones).
2. Click New.
It is recommended that the connection to the “Lync gateway” Cisco VCS uses SIP over TLS to
communicate so that encrypted calls can be handled. H.323 mode should also be enabled, so
that any interworking that has to be done for calls with Lync Server is carried out on the “Lync
gateway” Cisco VCS.
communicate so that encrypted calls can be handled. H.323 mode should also be enabled, so
that any interworking that has to be done for calls with Lync Server is carried out on the “Lync
gateway” Cisco VCS.
3. Configure the fields as follows:
Name
“To Video network”
Type
Neighbor
SIP mode
On
SIP port
5061 (or the value that is the same as that configured on the “Lync
gateway” Cisco VCS for TLS mode SIP)
gateway” Cisco VCS for TLS mode SIP)
SIP transport
TLS
TLS verify mode
Off
Accept proxied registrations
Deny
H.323 mode
On
In the Location section:
Peer 1 address
Peer 1 address
IP address or FQDN of the video network Cisco VCS (or the 1
st
Cisco
VCS in the Video network cluster)
In the Location section:
Peer 2 address to Peer 6
address
Peer 2 address to Peer 6
address
IP address or FQDN of the 2
nd
to 6th video network cluster peers (if
any)
In the Advanced section:
Zone profile
Zone profile
Default
4. Click Create zone.