Cisco Cisco TelePresence Video Communication Server Expressway
Enabling endpoints registered on the video network to call MOC/Lync clients registered on OCS/Lync
Cisco VCS Deployment Guide: Microsoft OCS 2007 R2, Lync 2010 and Cisco VCS X7.0
Page 34 of 104
4. Click Create search rule.
Video network: Set up search rules to route calls to any domains
supported on OCS/Lync (but not in the video network) to the
“OCS/Lync gateway” VCS (cluster)
supported on OCS/Lync (but not in the video network) to the
“OCS/Lync gateway” VCS (cluster)
There may be no additional domains supported by OCS/Lync, but if there are
1. Go to the
Search rules
page (
VCS configuration > Dial plan > Search rules
).
2. Click New.
3. Configure the following fields:
Rule name
An appropriate name, for example “Route domain xxx to OCS/Lync gateway”
Priority
Leave as default, for example 100
Source
Any
Mode
Alias pattern match
Pattern type
Regex
Pattern string
.+@<relevant domain>.*
Pattern behavior
Leave
On successful match
Stop
Target
Select the OCS/Lync gateway zone, for example “To OCS/Lync gateway”
4. Click Create search rule.
5. Repeat the process if additional search rules are needed, for example a search rule for the
dedicated MCU domain mcu.ciscotp.com.
“OCS/Lync gateway”: VCS Control configuration (1)
If “OCS/Lync gateway” is a cluster, unless this guide states that configuration is required on each
peer, configure the Master VCS in the cluster and allow the configuration to be replicated to the
other peers automatically.
peer, configure the Master VCS in the cluster and allow the configuration to be replicated to the
other peers automatically.
If the “OCS/Lync gateway” is just a single VCS then set up the configuration on that VCS.