Cisco Cisco TelePresence Video Communication Server Expressway
Configuring the Cisco VCS
Configure Cisco VCS’s Advanced Media Gateway settings
Identify Cisco AM GW zone and configure Cisco AM GW policy
This is where you select the Cisco AM GW zone to use, and decide whether to set up policy rules to
control which calls can use the Cisco AM GW.
1. Go to the Advanced Media Gateway configuration page (VCS configuration > Advanced
control which calls can use the Cisco AM GW.
1. Go to the Advanced Media Gateway configuration page (VCS configuration > Advanced
Media Gateway > Configuration).
2. Configure the fields as follows:
Advanced Media
Gateway zone
Gateway zone
Select the zone that you configured for the Cisco AM GWs
e.g. “To AM Gateway”
e.g. “To AM Gateway”
Policy mode
By default (where Policy mode is Off) all calls to or from OCS are
sent via the selected Cisco AM GW zone. If you want to limit which
calls go via the Cisco AM GW, set the Policy mode to On and then
set up policy rules to deny specific calls based on alias pattern
matches.
sent via the selected Cisco AM GW zone. If you want to limit which
calls go via the Cisco AM GW, set the Policy mode to On and then
set up policy rules to deny specific calls based on alias pattern
matches.
Off: all OCS calls go via the Cisco AM GW
On: allows control over which OCS calls go via the Cisco AM GW
3. Click
Save.
Note: If the Cisco AM GW reaches its capacity, any calls that would normally route via the Cisco AM
GW will not fail but will be routed directly. Any calls that are routed directly will not be able to support
the higher resolutions in MOC.
GW will not fail but will be routed directly. Any calls that are routed directly will not be able to support
the higher resolutions in MOC.
Cisco VCS Deployment Guide: Microsoft OCS 2007 R2, Cisco VCS Control X5.1
and Cisco AM GW 1.0
and Cisco AM GW 1.0
Page 8 of 24