Cisco Cisco TelePresence Video Communication Server Expressway 설치 가이드
Installing the Cisco VCS
If this product is mounted in a rack you are recommended to use additional support
accessories such as rack side support angles (rack angle brackets) or rack shelves, due
to the unit’s weight and depth. Ensure that units in the rack do not touch each other.
Contact your rack supplier to request the accessories best suited for your rack.
accessories such as rack side support angles (rack angle brackets) or rack shelves, due
to the unit’s weight and depth. Ensure that units in the rack do not touch each other.
Contact your rack supplier to request the accessories best suited for your rack.
Connecting the cables
1. Connect the power cable to the back of the Cisco VCS (see Figure 2).
2. Connect the Ethernet LAN cable from the LAN1 port on the front of the Cisco VCS to your network
2. Connect the Ethernet LAN cable from the LAN1 port on the front of the Cisco VCS to your network
(see Figure 3).
Powering on the Cisco VCS
1. Turn on the power switch on the back right of the unit (adjacent to the power cable). The system
will power up. If the unit does not start after 3 seconds, press the soft power button.
Wait until:
Wait until:
l
the green PWR LED on the front of the unit is a steady green color (it may flash briefly during
power up)
power up)
l
the red ALM LED on the front of the unit has gone out
l
the IP address is showing in the display panel on the front of the unit
If the red ALM LED flashes rapidly it indicates a hardware fault. Contact your local Cisco
representative. The yellow HDD LED indicates disk activity and may flicker during
normal operation, more so on a busy system.
representative. The yellow HDD LED indicates disk activity and may flicker during
normal operation, more so on a busy system.
Figure 2: Cisco VCS back view
VCS Getting Started Guide
Page 5 of 12