Cisco Cisco Web Security Appliance S360 릴리즈 노트

The documentation for the Cisco IronPort Web Security appliance includes the following books:

Use the following methods to obtain support:

U.S.: Call 1 (408) 526-7209 or Toll-free 1 (800) 553-2447 

International: http://www.cisco.com/en/US/support/tsd_cisco_worldwide_contacts.html 

Support Site: http://www.cisco.com/en/US/products/ps11169/serv_group_home.html 

If you purchased support through a reseller or another supplier, please contact that supplier directly with 
your product support issues.

This document is to be used in conjunction with the documents listed in the 

 section.

Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of 
Cisco trademarks, go to this URL: 

. Third-party trademarks mentioned are the property of their respective owners. The 

use of the word partner does not imply a partnership relationship between Cisco and any other company. (1110R)

Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be actual addresses and phone numbers. Any 
examples, command display output, network topology diagrams, and other figures included in the document are shown for illustrative purposes only. 
Any use of actual IP addresses or phone numbers in illustrative content is unintentional and coincidental.

28821

System reports false hard disk failure. Transient reports of hard disk failures might be 
erroneous. Performing a same drive hot swap resets the RAID firmware and likely 
resolves this issue. 

27887

No alerts for failed authentication servers. The Web Security appliance does not 
currently support alert messaging for failed authentication servers. To manage the 
appliance during such an event, use the advanced authentication settings to specify an 
action if the authentication server becomes unavailable. This option is located on the 
Network > Authentication page. 

23480, 23483, 
26979, 37384

Partial messaging for denied HTTP CONNECT requests. Some browsers truncate 
HTTP data that is sent in response to a CONNECT request. This means that if the Web 
Security appliance denies a CONNECT request, the “page cannot be displayed: 
Access Denied” error message might be incomplete. 

N/A

Specifying port 8080 is required to access the administration interface. To access the 
Web Security appliance management interface, you must connect using the appliance 
IP address and port number, 

http://192.168.42.42:8080

. Failing to specify a port 

number when accessing the web interface results in a default port 80, Proxy 
Unlicensed error page.

N/A

LDAP uses M1 management interface. Currently, all LDAP traffic is restricted to the 
M1 management interface. For this limitation, and any other LDAP-related issue, 
please contact IronPort Customer Support.