Cisco Cisco TelePresence Video Communication Server Expressway 관리 매뉴얼
7.
Click Locate to start the search.
The status bar shows Searching... followed by Search completed. The results include the list of zones that
were searched, any transforms and Call Policy that were applied, and if found, the zone in which the alias
was located.
were searched, any transforms and Call Policy that were applied, and if found, the zone in which the alias
was located.
The locate process performs the search as though the VCS received a call request from the selected Source zone.
For more information, see the
For more information, see the
Port Usage
The pages under the Maintenance > Tools > Port usage menu show, in table format, all the IP ports that have been
configured on the VCS.
configured on the VCS.
The information shown on these pages is specific to that particular VCS and varies depending on the VCS's
configuration, the option keys that have been installed and the features that have been enabled.
configuration, the option keys that have been installed and the features that have been enabled.
The information can be sorted according to any of the columns on the page, so for example you can sort the list by IP
port, or by IP address.
port, or by IP address.
Each page contains an Export to CSV option. This lets you save the information in a CSV (comma separated values)
format file suitable for opening in a spreadsheet application.
format file suitable for opening in a spreadsheet application.
Note that IP ports cannot be configured separately for IPv4 and IPv6 addresses, nor for each of the two LAN
interfaces. In other words, after an IP port has been configured for a particular service, for example SIP UDP, this will
apply to all IP addresses of that service on the VCS. Because the tables on these pages list all IP ports and all IP
addresses, a single IP port may appear on the list up to 4 times, depending on your VCS configuration.
interfaces. In other words, after an IP port has been configured for a particular service, for example SIP UDP, this will
apply to all IP addresses of that service on the VCS. Because the tables on these pages list all IP ports and all IP
addresses, a single IP port may appear on the list up to 4 times, depending on your VCS configuration.
The port information is split into the following pages:
■
■
■
On a VCS Expressway you can also configure the specific listening ports used for firewall traversal via Configuration
> Traversal > Ports.
> Traversal > Ports.
Local Inbound Ports
The Local inbound ports page (Maintenance > Tools > Port usage > Local inbound ports) shows the listening IP
ports on the VCS that are used to receive inbound communications from other systems.
ports on the VCS that are used to receive inbound communications from other systems.
For each port listed on this page, if there is a firewall between the VCS and the source of the inbound
communications, your firewall must allow:
communications, your firewall must allow:
■
inbound traffic to the IP port on the VCS from the source of the inbound communications, and
■
return traffic from that same VCS IP port back out to the source of the inbound communication.
Note:
this firewall configuration is particularly important if this VCS is a traversal client or traversal server, in order for
Expressway firewall traversal to function correctly.
Local Outbound Ports
The Local outbound ports page (Maintenance > Tools > Port usage > Local outbound ports) shows the source IP
ports on the VCS that are used to send outbound communications to other systems.
ports on the VCS that are used to send outbound communications to other systems.
For each port listed on this page, if there is a firewall between the VCS and the destination of the outbound
communications, your firewall must allow:
communications, your firewall must allow:
306
Cisco TelePresence Video Communication Server Administrator Guide
Maintenance